Kingdom of Italy (1941)
Two Seater Reconnaissance Aircraft – 2 Prototypes Built
With the development of new designs for the Italian Air Force, the need for a more advanced reconnaissance aircraft became apparent. Italians mostly used older biplanes for this role, which was far from a perfect solution, and thus a new design was needed. For this reason, one Re.2000 would be rebuilt and tested as a reconnaissance aircraft. Despite an initial order for serial production, only a few prototypes were ever built.
History
Officine Meccaniche Reggiane SA (Reggio Emilia in Northern Italy) was a WWI-era aircraft manufacturer. After the war it was not involved in any significant aircraft production or design work. Large scale production only began during the thirties, when Reggiane became a subsidiary of the much larger aircraft manufacturer Caproni, which was led by the well known engineer Gianni Caproni. Thanks to him, Reggiane was aided by Caproni’s larger and well qualified aircraft design department. Reggiane and Caproni were involved with several experimental pre-war designs, like the Ca.405 Procellaria and P.32bis, in addition to the licensed production of the S.M.79. In 1938, the development of the Re.2000 began with a request from the Italian Aviation Ministry (Ministero dell Aeronautica) under the codename “Programme R.” This was intended to upgrade the Italian Air Force (Regia Aeronautica) with new and modern designs.
Despite the time and resources involved in development, the resulting Re.2000 would not be adopted for the Italian Air Force. It would see service in countries like Sweden and Hungary in some numbers. Due to the demand for long range fighters and shipboard versions, a small number was adopted for service by the Italian Air Force. From the small number of Re.2000s seized by the Italian Air force, most were from the Series II and III. At least one was used as a base for the experimental two-seat Re.2003 version.
The Re.2003
In early 1941, Italian Air Force officials placed an order for a two-seater reconnaissance aircraft. Reggiane responded by simply reusing the already produced Re.2000 in order to speed up development and to streamline a potential production run. One Re.2000 (MM.478) was modified by adding an additional seat behind the pilot.
The prototype was completed very quickly, and by July it was ready for its first test flight. The test flight was carried out by Captain Francesco Aggelo. The flight was considered successful, but certain modifications were required. These include redesigning the rear observer’s cockpit and the installation of camera equipment. Once these modifications were made, the test flights were resumed in November 1941 with two new pilots.
The Re.2003 seems to have fulfilled all requirements that were demanded. On the 16th of December 1941, an official order for the production of 200 Re.2003 was placed at Reggiane. Production was to commence before September 1942.
The Second Prototype
Reggiane engineers and designers began working on an improved second prototype in 1942, based on the Re.2002 (MM.12415). The decision to use the Re.2002 was probably based on the fact that it was put into production and was in (very limited) use during the war. In addition, while the Re.2000 was being produced for the export market, it was not adopted for Italian aviation use. Simply put, production in larger quantities was not possible.
Technical Characteristics
The Re.2003 was originally based on the Re.2000, and for this reason, the cosmetic and structural differences were minimal. The Re.2003 was a low wing, mixed construction, but mostly metal, two-seater reconnaissance plane. The fuselage consisted of a round frame covered with aluminum sheets held in place by flush-riveting. The Re.2003’s wings had a semi-elliptical design, with five spars covered with stressed skin. The wings were equipped with fabric-covered Frise type ailerons. The tail had a metal construction, with the controls surfaces covered with fabric. The fuel was stored in the wings, but the precise quantity is not known.
The landing gear system was unusual. When it retracted backward, it rotated 90° (a copy of the Curtiss type) before it moved into the wheel bays. For better handling when landing, the landing gear mechanism was provided with hydraulic shock absorbers and pneumatic brakes. The smaller rear wheel was also retractable and could be steered if needed.
The Re.2003’s engine was the stronger Piaggio P.XI bis RC.40, which had around 1025 hp. Due to being used in limited test flights, precise engine performance is not clear. Author Jonathan Thomson noted that the maximum speed was around 471 km/h (293 mph). The first prototype had the Re.2000’s original engine cowling. The second prototype had a more aerodynamically-shaped cowling, as it was based on the Re.2002.
The most obvious difference was the larger canopy. The front pilot canopy section was more or less the same as the Re.2000. The rear section was somewhat larger in order to provide the observer with a better view. In addition, two small glass windows were added on both sides of the fuselage sides for the observer.
The main armament was not changed and consisted of two Breda-Safat 12.7 mm ( 0.5 in) heavy machine guns. The machine guns were placed in the top of the front cowling and fired through the propeller arc. For each machine gun, a provision of 300 rounds was provided. The machine guns could, depending on the combat situation (lack of ammunition, for example), be fired together or individually. The Re.2003 was also tested with a bomb load of 500 kg (1100 lb) placed on the ventral rack.
Operational Use
The Re.2003 first prototype was used by the 1st Gruppo Reserve Aerea (Reserve 1st Air Group), possibly from late 1942 up to the Italian capitulation in 1943. It was then captured by the Germans, who used it as a trainer aircraft. This aircraft, while in German hands, was stationed at the Caproni-Taliedo airfield. Its final fate is unknown.
Cancellation of the Project
The following year, due to the rapid military deterioration of the Italian Air Force, the need for more advanced fighters had greater priority over other projects. Work on the Re.2003 was slow and, by late 1942, little progress had been made. The second prototype’s development was also proceeding at a slow pace. It made its first test flight in October 1942. Some historians note that the second prototype was never fully completed. In order to increase the production of fighter designs, Reggiane was asked to stop the development of the Re.2003, and instead focus on the production of fighter planes. Only the two prototypes were ever built.
Re.2003 first prototype (MM.478) – One prototype built and used in a limited role.
Re.2003 second prototype (MM.12415) – Based on the Re.2002, one built.
Operators
- Italy – Operated the first prototype during the war.
- Germany – Captured one prototype in 1943. It was used as a trainer plane.
Conclusion
Due to the Re.2003’s short development life, it is not known if it could have fulfilled the purpose the Italian Air Force officials had intended for it. It appears that no major problems were encountered during its development, so there is no indication it had any problems fulfilling its role as a reconnaissance plane. However, without ever being properly tested in real combat conditions, this will never be known.
Re.2003 Specifications |
||
| Wingspan | 36 ft 1 in / 11 m | |
| Length | 26 ft 5 in / 8 m | |
| Height | 10 ft 4 in / 3.15 m | |
| Wing Area | 220 ft² / 20.4 m² | |
| Engine | One Piaggio P.XI RC.40bis, 1025 hp | |
| Maximum Takeoff Weight | 7,210 lbs / 3,270 kg | |
| Maximum Speed | 293 mph / 471 km/h | |
| Range | 447 miles / 720 km | |
| Crew | Pilot and observer | |
| Armament |
|
|
Gallery
Sources:
- D. Nešić (2008) Naoružanje Drugog Svetsko Rata-Italija. Beograd.
- M. Di Terlizzi (2002) Reggiane RE 2000 Falco, Heja, J.20, Instituto Bibliografico Napoleone.
- J. W. Thompson (1963) Italian Civil And Military Aircraft 1930-1945, Aero Publisher
- G. Cattaneo (1966) The Reggiane Re.2000, Profile Publication Ltd.
- J. F. Bridlay (1972) Caproni Reggiane Re 2001 Falco II, Re 2002 Ariete and Re 2005 Sagittario, Profile Publications